Floating Clamp - 23320.0012

*Please note, there is a $50 minimum for all Halder product orders*

Short Description

Full Description

The floating clamp is used to clamp and support additional clamping points on components.

The benefits of the floating clamp are:

• avoids vibration during the processing
• clamps ribs, beads and shackles to reinforce clamped components
• distortion-free clamping of raw parts.

Material

Adjustable body

• Aluminium, red anodised

Body

• Case hardened steel, nitrided, manganese phosphate treated and ground

Clamping Jaws

• Case hardened steel, nitrided, manganese phosphate treated

Assembly

• Mount the floating clamp (M12 connection thread) onto the device with a wrench (WS46).
• Adjust the height limit stop and the rotating area with the red sleeve and clamp with a set screw (3xWS2.5). When setting the height limit, consider tolerance of workpiece.

Operation

• Push the floating clamp downwards.
• Pivot the clamping jaws in as far as possible. The floating clamp contacts the bottom of the workpiece with a slight spring load.
• Tighten the floating clamp with a hexagonal nut (WS 18) having a min. torque of 15 Nm and a maximum torque of 30 Nm. In the clamping process, the workpiece is clamped and simultaneously supported.
• Releasing is done in reverse order.

Notes

The thread bore must always be closed for safe functioning, e.g. set screw M 12 x 10.

For specific clamping situations, the standard clamping jaws supplied can be exchanged or replaced (see catalogue drawing: screw ISO4762-M8-12.9, Mmax.=43Nm).

References

Additional flexible possibility of fitting with holder 23470.0250 or holding plate for down-hold clamps 23210.0740.

Accessories

As an accessory, we offer clamping jaws with an increased clamping range, refer to 23320.0050-.0058, as well as pivot jaws, refer to 23320.0148-.0156.

Halder 23320.0012 Data Sheet