Compact push/pull toggle clamps for mounting through panels, plates, or angle brackets. Install in a drilled or tapped hole, securing with the locknut provided. Rotate clamp to position handle anywhere within 360°. Plunger locks in either extended or retracted position. Choice of three sizes, with inch or metric tapped plunger. Two of these sizes are optionally available with our patented self-adjusting plunger. The self-adjusting version clamps only in the "push" direction and is not tapped for a spindle.
Allows operating a single clamp, or group of clamps, at a lower pressure than the rest of the fixture. Can be used to finely adjust the clamping force of selected components while keeping others at full pressure. Great new design can be used on pallet fixtures disconnected from a power source, since no return line is needed for operation. Zero-leakage poppet design. The threaded-body version shown here is used for cartridge-type manifold mounting. Also available with standard fittings for use with exposed fluid lines, and a manifold-mounted version for mounting on flat surfaces.