Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Pressure-Reducing Valves (Standard Fittings)

    Pressure-Reducing Valves (Standard Fittings)

    Power Workholding

    7250 psi max
    Pressure-Reducing Valves allow operating a single clamp, or group of clamps, at a lower pressure than the rest of the fixture. These valves can be used to finely adjust the clamping force of selected components while keeping others at full pressure. Great new design can be used on pallet fixtures disconnected from a power source since no return line is needed for operation. Zero-leakage poppet design. The version shown here is used for in-line mounting with standard fittings and exposed fluid lines. Also available in a manifold-mounted version for mounting on flat surfaces, and a threaded-body version for cartridge-type manifold mounting.

    Operation

    To set up initially, turn the adjustment screw on top until the desired downstream pressure is achieved. During normal operation, Pressure-Reducing Valve automatically shuts off downstream flow when system pressure reaches the set pressure. As long as the system remains connected to the power source, the valve will reopen if additional fluid is required to maintain downstream pressure.

    Design Considerations

    When using this valve in series with other valves such as Clamping Valves, Sequence Valves, and Flow-Control Valves, the Pressure-Reducing Valve must be the one closest to the reduced-pressure clamps. When a Pressure-Reducing Valve is used in an uncoupled system, no regulation of downstream pressure is possible after disconnection, so we strongly recommend adding a Pressure-Relief Valve to guard against unwanted pressure increases caused by temperature increases, etc. (must be added to the downstream side).

    Mounting & Fluid Supply

    Mount in-line. Fasten valve to fixture using a 5/16 or M8 cap screw if desired. Mount in any position, horizontal or vertical. Two 1/4" BSPP ports. Do not use NPT fittings.

    View as Grid List
    Sort by
    Display per page

    pressure reducing Valve,secondary pressure 30 - 380 bar, tube connection g1/4, 500 bar CL-CLR-2953-111-V

    SKU: CL-CLR-2953-111-V
    MPN: CLR-2953-111-V
    Email Sales for Pricing
    Allows operating a single clamp, or group of clamps, at a lower pressure than the rest of the fixture. Can be used to finely adjust the clamping force of selected components while keeping others at full pressure. Great new design can be used on pallet fixtures disconnected from a power source, since no return line is needed for operation. Zero-leakage poppet design. The version shown here is used for in-line mounting with standard fittings and exposed fluid lines. Also available in a manifold-mounted version for mounting on flat surfaces, and a threaded-body version for cartridge-type manifold mounting.

    Pressure-Reducing Valves (Standard Fittings)