Close
(0) items
You have no items in your shopping cart.
All Categories
    Filters
    Preferences
    Search

    Screw Pumps (Block Type)

    Screw Pumps (Block Type)

    Power Workholding

    7250 psi max
    For Single-Acting Systems

    Screw Clamps are an ideal hydraulic pressure source for small clamping fixtures that must be independent of an external power source. Small enough to mount directly on the fixture. Can be operated manually with a crank handle or using a power torque wrench (non-impact type). Produces 7250 psi hydraulic pressure from only 40 ft-lbs torque. Can be used in multiples if greater fluid capacity is required. The block type shown here allows convenient mounting when using exposed fluid lines.

    Operation

    Turn screw shaft clockwise to clamp. Tighten until the desired pressure is reached (read pressure on a separate gauge, or tighten to a predetermined torque). Turn counterclockwise to unclamp.

    Design Considerations

    In closed systems such as this, all clamps and components must be leak-free, so use only Roemheld products. For best results, clamps should use only 60-70% of the Screw Pump's total fluid capacity. System plumbing must be designed to avoid air pockets. If Screw Pump is not at the highest point in the system, include a separate fill plug at the highest point. Always include a pressure gauge on the fixture when using a Screw Pump. When using an accumulator, use only the smallest size (CLR-9606-102-PDA) due to limited fluid capacity. For additional safety on palletized fixtures, use a Control Cylinder, with position sensing on the machine tool.

    Mounting & Setup

    Mount horizontally with fluid fill port up. Fasten with two cap screws. Fill system with clean, approved Hydraulic Fluid with the pump piston fully returned. The system must be totally purged of air. Do not use NPT fittings.

    View as Grid List
    Sort by
    Display per page

    SCREW PUMP CL-CLR-900-SP

    SKU: CL-CLR-900-SP
    MPN: CLR-900-SP
    Email Sales for Pricing
    Screw Clamps are an ideal hydraulic pressure source for small clamping fixtures that must be independent of an external power source. Small enough to mount directly on the fixture. Can be operated manually with a crank handle or using a power torque wrench (non-impact type). Produces 7500 psi hydraulic pressure from only 40 ft-lbs torque. Can be used in multiples if greater fluid capacity is required. The block type shown here allows convenient mounting when using exposed fluid lines.

    SCREW PUMP, DISPLACEMENT = 21 cm¦, 25 x 43 mm STROKE, BLOCK-TYPE VERSION, 500 bar CL-CLR-8819-001-SP

    SKU: CL-CLR-8819-001-SP
    MPN: CLR-8819-001-SP
    Email Sales for Pricing
    Screw Clamps are an ideal hydraulic pressure source for small clamping fixtures that must be independent of an external power source. Small enough to mount directly on the fixture. Can be operated manually with a crank handle or using a power torque wrench (non-impact type). Produces 7500 psi hydraulic pressure from only 40 ft-lbs torque. Can be used in multiples if greater fluid capacity is required. The block type shown here allows convenient mounting when using exposed fluid lines.

    Screw Pumps (Block Type)