SAE Port Fittings (37-Degree Flare)

Power Workholding

CLR-705-F
These adaptor fittings allow using other brands of power-workholding components that have SAE O-ring ports in our standard power-workholding systems (5/16" O.D. tubing). Please note: SAE O-ring fittings are limited to 5000 psi operating pressure and limit the entire system to that pressure.

Straight port fitting with a 5/16" male JIC 37° end fits #4 SAE ports. For components with #6 SAE ports, use the reducing adaptor along with the port fitting. JIC-standard 37° fittings accept our standard 5/16" O.D. tubing (cut off straight, deburred, and flared) as well as Fixture Hose and Heavy-Duty Hose with 37°-flare swivel nuts. When using tubing, a Tube End fitting (CLR-400-F), consisting of a nut and sleeve, must be placed on each tube end before flaring is completed.

Available Sizes

CLR-705-F - For #4 SAE Port
CLR-706-F - #6 SAE to #4 SAE Reducing Adaptor

Design Considerations & Safety Precautions

Use these fittings only with our standard tubing and hose. Our standard tubing is 5/16" O.D. seamless heavy-wall tubing, C1010 steel, cold drawn, fully annealed, .065" wall thickness, 22,800 psi minimum burst pressure. SAE O-ring fittings are limited to 5000 psi operating pressure and limit the entire system to that pressure. Other brands of power-workholding components are usually not totally leak-free, so they should not be used on pallet fixtures disconnected from the hydraulic power source.

Material

Steel, with rubber O-ring. DFARS and RoHS compliant.